DESIGN AND VERIFICATION OF CLASSICAL CONTROLLER FOR TRANSFORMER LESS DC-DC BOOST CONVERTER

Authors

  • V.Venkata Nagendra PG student, Department of Electrical and Electronics Engineering, Vishnu Institute of Technology, Bhimavaram, Andhra Pradesh, India
  • K. Ramash Kumar Professor, Department of Electrical and Electronics Engineering, Vishnu Institute of Technology, Bhimavaram, Andhra Pradesh, India-534202
  • V.S.N. Narasimha Raju Assistant Professor, Department of Electrical and Electronics Engineering, Vishnu Institute of Technology, Bhimavaram, Andhra Pradesh, India-534202

Keywords:

Transformer less DC-DC boosts converter (TDC-DCBC), Proportional plus Integral (PI) controller, Continuous Conduction Mode (CCM), Classical Controllers (CC), MATLAB/Simulink

Abstract

This article studies on a design and Verification of classical controllers (CC) for Transformer less DC-DC Boost Converter (TDC-DCBC) operated in Continuous Conduction Mode (CCM) for applications wanting a stable power source in I-pad, mobile phones, MP-3 player, lap-top computers, robot interface communication device and solar energy etc.,.  Attributable to the ON/OFF characteristics of TDC-DCBC is non-linear in nature and it generates meager dynamic performances and also, unsatisfactory output voltage regulation. With the aim of increase the dynamic performance and output voltage regulation of TDC-DCBC, a CC is designed. In this article proportional integral (PI) controller is taken as one of the CC. The PI controller parameters are arrived from the modeling of TDC-DCBC with help of the state space averaging approach. The performance of the designed converter with PI controller is validated at different operating state by building both matrix laboratory (MATLAB)/simulation link (Simulink). The results are presented to prove the performance designed converter with CC.

References

I. Y. P. Hsieh, J. F. Chen, T. J. Liang, and L. S. Yang, Novel high step -up DC-DC converter for distributed generation system,‖ IEEE Trans. Ind.Electron., vol. 60, no. 4, pp. 1473–1482, Apr. 2013.

II. W. and He, W. Review of Non-Isolated High Step-Up DC/DC Converters in Photovoltaic Grid-Connected Applications. IEEE Transaction on Industrial Electronics, 58, 1239-1250. http://dx.doi.org/10.1109/TIE.2010.2049715

III. M. Nymand, M.A.E. Andersen, High-efficiency isolated boost DCeDC converter for high-power low-voltage fuel-cell applications, Trans. IEEE Industrial Electronics, 57 (2) (February 2010) 505e514.

IV. R. W. Erickson and D. Maksimovic, Fundamentals of Power Electronics, 2nd ed. New York, NY: Springer- Verlag, 2001.

V. M. H. Todorovic, L. Palma, and P. N. Enjeti, Design of a wide input range dc –dc converter with a robust power control scheme suitable for fuel cell power conversion,‖ IEEE Trans. Ind. Electron., vol. 55, no. 3, pp. 1247–1255, Mar. 2008.

VI. Zhu. L.A Novel Soft-Commutating Isolated Boost Full bridge ZVS-PWM DC-DC Converter for Bidirectional High Power Applications. IEEE Transaction on Power Electronics, (2006) 21, 422-429.

VII. R. J. Wai, C. Y. Lin, C. Y. Lin, R. Y. Duan, and Y. R. Chang, High efficiency power conversion system for kilowatt-level stand-alone generation unit with low input voltage,‖ IEEE Trans. Ind. Electron., vol. 55, no. 10, pp. 3702–3714, Oct. 2008.

VIII. S. K. Changchien, T. J. Liang, J. F. Chen, and L. S. Yang, ―Novel high step up dc-dc converter for fuel cell energy conversion system,‖ IEEE Trans Ind. Electron, vol. 57, no. 6, pp. 2007–2017, Jun. 2010.

IX. S. Chen, T. Liang, L. Yang, and J. Chen, A cascaded high step -up dc–dc converter with single switch for micro source applications,‖ IEEE Trans.Power Electron., vol. 26, no. 4, pp. 1146–1153, Apr. 2011.

X. S. V., J. P. F., and Y. L., ―Optimization and design of a cascaded DC/DC converter devoted to grid –connected photovoltaic systems,‖ IEEE Trans. Power Electron., vol. 27, no. 4, pp. 2018–2027, Apr. 2012.

XI. Lin, B.R. and H.H. Lu, Single-phase three-level PWM rectifier, in Proc. IEEE APEC’99, 1999. pp: 63-68.

XII. Dongyan Z., Pietkiewicz A., Cuk S.: “A three-switch high voltage converter”, IEEE Transactions on Power Electronics. vol. 14, no. 1, pp. 177–183, 1999.

XIII. Maksimovic D., CUK S.: “Switching converters with wide DC conversion range”, IEEE Transactions on Power Electronics. vol. 6, no 1, pp. 151–157, 1991.

XIV. Pires, V. F., Silva, J. F. A. (2002), Teaching Nonlinear Modeling, Simulation and Control of Electronic Power Converters Using MATLAB/SIMULINK, IEEE Transactions on Education, vol. 45, no. 3, August.

XV. Mahdavi, J., Emadi, A., Toliyat, H.A. Application of State Space Averaging Method to Sliding Mode Control of PWM DC/DC Converters, IEEE Industry Applications Society October (1997).

XVI. Brigitte Hauke, Basic Calculation of a Boost Converter’s Power Stage, Texas Instruments- Application Report SLVA372C, pp.1-8, 2014.

Additional Files

Published

15-05-2017

How to Cite

V.Venkata Nagendra, K. Ramash Kumar, & V.S.N. Narasimha Raju. (2017). DESIGN AND VERIFICATION OF CLASSICAL CONTROLLER FOR TRANSFORMER LESS DC-DC BOOST CONVERTER. International Education and Research Journal (IERJ), 3(5). Retrieved from https://ierj.in/journal/index.php/ierj/article/view/1028

Issue

Vol. 3 No. 5 (2017): MAY ISSUE, INTERNATIONAL EDUCATION AND RESEARCH JOURNAL

Section

Articles

License

Copyright (c) 2021 International Education and Research Journal (IERJ)

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.